Smarter Tools STPT-KIT-38PC Manuel d'utilisation et d'entretien télécharger pdf (Page 11)

4. The amount of paint being applied can be varied by the speed of the

stroke, distance from the surface and adjustment of the fluid control

knob.

5. Overlap strokes just enough to obtain an

even coat (See Figure 11).

NOTE:

Two thin coats of paint will yield better results and have less

chance of runs than one heavy layer.

6. Use a piece of cardboard as a shield to catch overspray at the edges of

the work to protect other surfaces. Use masking tape to cover other

areas if needed.

Maintenance

DAILY CLEAN-UP

Local codes may require specific cleaning methods and equipment. Follow local

codes and paint manufacturer’s recommendations for the use and disposal of

spray materials and solvent.

CAUTION:

CLEAN SPRAY GUN IMMEDIATELY AFTER USE. PAINT AND

OTHER MATERIALS DRY QUICKLY IN THE SMALL PASSAGES

RENDERING GUN USELESS DUE TO THE DIFFICULTY OF

REMOVING HARDENED PAINT FROM THE PASSAGES INSIDE

THE GUN.

NOTE:

In the instructions below, the use of the word “solvent” refers to

the specific solvent for the material used (example: lacquer

thinner for lacquer, etc.).

1. Remove and empty the canister; then rinse with a solvent

recommended for the paint or other material used.

2. Refill canister with clean solvent and attach to the gun. Spray solvent

through the gun while shaking the gun vigorously. Wipe the gun

exterior with a solvent soaked rag. Repeat until the gun is clean.

1 2 ... 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Smarter Tools STPT-KIT-38PC Manuel d'utilisation et d'entretien Page 11